How to Reset the Engine Light on a 2012 Nissan Rogue

Step 1: Gather your tools

You will need the following tools to reset the engine light on your 2012 Nissan Rogue:

* A scan tool or code reader
* A flat-head screwdriver
* A pair of pliers

Step 2: Locate the diagnostic port

The diagnostic port on a 2012 Nissan Rogue is located under the dashboard, to the left of the steering wheel. It is a small, black port with a 16-pin connector.

Step 3: Connect the scan tool

Connect the scan tool to the diagnostic port using the 16-pin connector. Turn on the ignition, but do not start the engine.

Step 4: Read the trouble codes

Once the scan tool is connected, it will automatically read the trouble codes from the engine control module (ECM). These codes will indicate what caused the engine light to come on.

Step 5: Clear the trouble codes

Once you have read the trouble codes, you can clear them using the scan tool. To do this, follow the prompts on the scan tool.

Step 6: Disconnect the scan tool

Once the trouble codes have been cleared, you can disconnect the scan tool from the diagnostic port.

Step 7: Start the engine

Start the engine and check to see if the engine light is still on. If the engine light is off, then the reset was successful.

Tips

* If you do not have a scan tool, you can take your car to a mechanic to have the engine light reset.
* If the engine light comes back on after you have reset it, there may be a more serious problem with your car. You should take your car to a mechanic for further diagnosis.
* You can also use a code reader to read and clear the trouble codes on your car. Code readers are less expensive than scan tools, but they do not have all of the same features.

Conclusion

Resetting the engine light on a 2012 Nissan Rogue is a simple process that can be done in a few minutes. By following the steps outlined in this guide, you can save yourself the time and expense of taking your car to a mechanic.