How to Renew Car Engine Transmission

1. Gather the necessary tools and materials.

You will need the following tools and materials to renew your car’s engine transmission:

* A new engine transmission
* A transmission jack
* A set of wrenches
* A set of sockets
* A torque wrench
* A fluid pump
* Transmission fluid
* A filter wrench
* A new filter
* A gasket scraper
* A new gasket

2. Remove the old engine transmission.

1. Disconnect the negative battery terminal.
2. Raise the car and support it on jack stands.
3. Remove the driveshaft.
4. Remove the starter.
5. Remove the torque converter bolts.
6. Remove the transmission mount bolts.
7. Lower the transmission using the transmission jack.

3. Prepare the new engine transmission.

1. Clean the mating surfaces of the engine and transmission.
2. Install the new gasket.
3. Install the new filter.

4. Install the new engine transmission.

1. Lift the new transmission into place using the transmission jack.
2. Bolt the transmission to the engine.
3. Install the torque converter bolts.
4. Install the starter.
5. Install the driveshaft.
6. Lower the car.

5. Fill the transmission with fluid.

1. Use the fluid pump to fill the transmission with fluid.
2. Check the fluid level and add more fluid if necessary.

6. Connect the battery.

1. Connect the negative battery terminal.

7. Test drive the car.

1. Start the car and let it idle for a few minutes.
2. Shift through all of the gears and make sure that the transmission is working properly.

Renewing your car’s engine transmission is a complex and time-consuming process, but it is essential for keeping your car running properly. By following these steps, you can save yourself a lot of money and time in the long run.