How to Remove Car Engine Oil from Driveway

Safety Precautions

Before attempting to remove car engine oil from your driveway, it is important to take the necessary safety precautions.

To remove car engine oil from your driveway, you will need the following materials:

Absorb the Oil

Spread kitty litter or sawdust over the oil spill and allow it to sit for several hours or overnight. This will absorb the oil and make it easier to remove.
Sweep Up the Absorbent

Once the oil has been absorbed, sweep up the kitty litter or sawdust and dispose of it properly.
Clean the Area

Mix a few drops of dish soap with water in a bucket. Dip a sponge or brush into the solution and scrub the area where the oil spill was located.
Rinse the Area

Rinse the area thoroughly with water from a hose. You may need to use a pressure washer to remove all of the oil residue.
Repeat Steps if Necessary

If there is still oil residue on the driveway, repeat steps 3 and 4 until the area is clean.

The sooner you address the oil spill, the easier it will be to remove.
Kitty litter or sawdust is a good absorbent for oil spills, but you can also use other materials such as sand or newspaper.
Do not use bleach or other harsh chemicals to clean the area, as this can damage the driveway surface.
If the oil spill is large or has soaked into the driveway, you may need to call a professional cleaning service.

Do not pour oil down the drain, as this can clog the pipes.
Do not burn the oil-soaked kitty litter or sawdust, as this can create toxic fumes.
Keep oil spills away from heat sources, as this can cause a fire.

If the oil spill is on a porous surface such as concrete, you may need to seal the area after cleaning to prevent further staining.
If you are unsure how to remove car engine oil from your driveway, it is best to consult with a professional.