## How to Put Engine on Stand in My Summer Car
**Introduction**
My Summer Car is a realistic vehicle simulator where players must maintain, repair, and drive a dilapidated Satsuma AMP. One of the most challenging tasks in the game is putting the engine on a stand for repairs. This process requires patience, attention to detail, and a deep understanding of the game’s mechanics.
**Step 1: Prepare the Vehicle**
* Park the Satsuma on a level surface with the parking brake engaged.
* Open the hood and remove the battery.
* Disconnect the fuel lines from the carburetor.
* Attach a hoist or engine crane to the engine using the designated lifting points.
**Step 2: Position the Stand**
* Place an engine stand under the engine, aligning the attachment points with the corresponding bolts on the engine block.
* Secure the engine stand to the bolts using nuts and washers.
**Step 3: Lift the Engine**
* Slowly lift the hoist or engine crane to raise the engine.
* Ensure that the engine is securely attached to the stand by checking the bolts and connections.
**Step 4: Disconnect Transmission and Mounts**
* Remove the bolts holding the transmission to the engine.
* Unbolt the engine mounts from the chassis.
* Carefully pull the engine away from the transmission.
**Step 5: Remove the Engine**
* Continue lifting the engine until it is clear of the engine bay.
* Remove the engine from the hoist or engine crane.
**Step 6: Inspect and Repair Engine**
* Place the engine on a workbench or other stable surface.
* Inspect the engine for any damaged or worn parts.
* Replace or repair any necessary components, such as gaskets, seals, or pistons.
**Step 7: Reassemble the Engine**
* Once the repairs are complete, reassemble the engine by reversing the steps from disassembly.
* Install new gaskets and seals as needed.
* Tighten all bolts and connections to the manufacturer’s specifications.
**Step 8: Install Engine on Stand**
* Place the engine on the engine stand and secure it with the bolts and washers.
* Ensure that the engine is balanced and level.
**Step 9: Reconnect Transmission and Mounts**
* Reattach the transmission to the engine using the bolts.
* Reinstall the engine mounts and tighten the bolts.
**Step 10: Reinstall Engine in Vehicle**
* Carefully lift the engine using the hoist or engine crane.
* Position the engine in the engine bay and align it with the transmission.
* Lower the engine into place and secure it to the chassis using the engine mounts.
**Step 11: Reconnect Fuel Lines and Battery**
* Reconnect the fuel lines to the carburetor.
* Install the battery and connect the terminals.
**Step 12: Start the Engine**
* Cross your fingers and start the engine.
* Listen for any unusual noises or vibrations that could indicate a problem.
* If the engine starts and runs smoothly, you have successfully completed the process of putting the engine on a stand and repairing it.
**Conclusion**
Putting the engine on a stand in My Summer Car is a challenging but rewarding task. By following these steps carefully and patiently, you can complete the process safely and effectively, allowing you to get your Satsuma AMP back on the road. Remember, practice makes perfect, and the more you work on your car, the more comfortable and efficient you will become at repairs and maintenance.
