- How to Drain Engine Oil on a Smart Car
- Materials You’ll Need
- Safety Precautions
- Step-by-Step Instructions
- 1. Locate the Oil Drain Plug
- 2. Place the Oil Drain Pan
- 3. Loosen the Oil Drain Plug
- 4. Allow the Oil to Drain
- 5. Replace the Oil Drain Plug
- 6. Locate the Oil Filter
- 7. Remove the Oil Filter
- 8. Apply Oil to the New Oil Filter
- 9. Screw on the New Oil Filter
- 10. Add New Engine Oil
- 11. Check the Oil Level
- 12. Start the Engine
- 13. Check for Leaks
- Tips
- Conclusion
How to Drain Engine Oil on a Smart Car
Materials You’ll Need
- New engine oil
- New oil filter
- Oil drain pan
- Funnel
- Wrench
Safety Precautions
- Park your car on a level surface and engage the parking brake.
- Allow the engine to cool down completely before starting.
- Wear gloves and eye protection.
Step-by-Step Instructions
1. Locate the Oil Drain Plug
The oil drain plug is located on the bottom of the oil pan. It is typically a 17mm bolt.
2. Place the Oil Drain Pan
Place the oil drain pan under the oil drain plug.
3. Loosen the Oil Drain Plug
Use the wrench to loosen the oil drain plug. Be careful not to overtighten or strip the bolt.
4. Allow the Oil to Drain
Allow the oil to drain into the oil drain pan. This may take a few minutes.
5. Replace the Oil Drain Plug
Once the oil has drained, replace the oil drain plug. Tighten the plug until it is snug, but do not overtighten.
6. Locate the Oil Filter
The oil filter is located on the side of the engine. It is typically a black or blue cylinder.
7. Remove the Oil Filter
Use the wrench to loosen the oil filter. Be careful not to spill any oil.
8. Apply Oil to the New Oil Filter
Apply a thin layer of oil to the gasket of the new oil filter.
9. Screw on the New Oil Filter
Screw on the new oil filter by hand until it is tight. Then, use the wrench to tighten the filter an additional 3/4 of a turn.
10. Add New Engine Oil
Use the funnel to add new engine oil to the engine. Add the amount of oil specified in your owner’s manual.
11. Check the Oil Level
Use the dipstick to check the oil level. The oil level should be between the “min” and “max” marks on the dipstick.
12. Start the Engine
Start the engine and let it run for a few minutes. This will circulate the new oil throughout the engine.
13. Check for Leaks
Check under the car for any oil leaks. If you see any leaks, tighten the oil drain plug or oil filter as needed.
Tips
- Change your engine oil every 3,000 to 5,000 miles, or as recommended by your owner’s manual.
- Use the correct type of engine oil for your car.
- Dispose of used engine oil and oil filters properly.
Conclusion
Draining engine oil on a Smart Car is a relatively easy task that can be completed in about 30 minutes. By following the steps outlined in this guide, you can safely and effectively change your engine oil and keep your car running smoothly.
