How to Check Ford Fusion 2010 Car Engine Codes

Introduction

Engine codes are used to identify the specific type of engine that is installed in a vehicle.
This information can be useful when troubleshooting problems with the engine, as well as when ordering parts.
There are a few different ways to check the engine code for a Ford Fusion 2010.

Method 1: Using the Vehicle Identification Number (VIN)

The VIN is a unique 17-digit code that is assigned to every vehicle.
It can be found on the driver’s side door jamb, as well as on the vehicle’s registration and insurance cards.
To check the engine code using the VIN, visit the following website:

https://www.decodethis.com/Ford-VIN-Decoder

Enter the VIN into the VIN decoder and click on the “Decode” button.
The engine code will be listed under the “Engine” section.

Method 2: Using the Engine Code Label

The engine code label is a small sticker that is attached to the engine.
It is usually located on the top of the engine, near the intake manifold.
The engine code will be printed on the label.

Method 3: Using a Scan Tool

A scan tool is a diagnostic tool that can be used to read engine codes.
To use a scan tool, connect it to the vehicle’s diagnostic port.
The diagnostic port is usually located under the dashboard, near the steering wheel.
Once the scan tool is connected, turn on the ignition and select the “Engine Codes” option.
The scan tool will display the engine codes that are stored in the vehicle’s computer.

Conclusion

Checking the engine code for a Ford Fusion 2010 is a simple process.
By following the steps outlined in this article, you can quickly and easily find the engine code for your vehicle.