How to Change the Car Engine Filter: Engine Life

Introduction

The engine filter is a vital part of your car’s engine. It helps to keep dirt and debris out of the engine, which can help to extend the life of your engine. Changing the engine filter is a relatively simple task that can be done in about 30 minutes.

Materials Needed

New engine filter
Wrench
Funnel
Oil
Rags

Instructions

Locate the engine filter. The engine filter is usually located in the front of the engine, near the top. It is a cylindrical-shaped object with a black or blue cap.
Loosen the engine filter cap. Use the wrench to loosen the engine filter cap. Do not remove the cap completely.
Remove the old engine filter. Once the engine filter cap is loose, you can remove the old engine filter. Be careful not to spill any oil.
Inspect the old engine filter. The old engine filter should be inspected for dirt and debris. If the engine filter is dirty, it should be replaced.
Lubricate the new engine filter. Apply a thin layer of oil to the gasket of the new engine filter. This will help to create a seal and prevent leaks.
Install the new engine filter. Insert the new engine filter into the engine filter housing. Tighten the engine filter cap until it is snug.
Add oil to the engine. Use the funnel to add oil to the engine. Add the amount of oil that is specified in your car’s owner’s manual.
Start the engine. Start the engine and let it run for a few minutes. This will circulate the oil and help to remove any air bubbles from the system.
Check for leaks. Check for leaks around the engine filter. If there are any leaks, tighten the engine filter cap until the leaks stop.

Conclusion

Changing the engine filter is a simple task that can help to extend the life of your engine. By following these instructions, you can change the engine filter in about 30 minutes.