How to Change Oil in Club Car Subaru Engine

Materials Needed

• New oil filter
• New oil (check your owner’s manual for the recommended type and amount of oil)
• Oil pan
• Funnel
• Wrench
• Gloves

Safety Precautions

• Allow the engine to cool before starting work.
• Wear gloves to protect your hands from hot oil.
• Dispose of used oil and filter properly.

Step-by-Step Instructions

1. Gather your materials and safety gear.

2. Locate the oil drain plug and oil filter.

The oil drain plug is typically located on the bottom of the oil pan. The oil filter is usually located near the top of the engine.

3. Place the oil pan under the oil drain plug.

4. Loosen the oil drain plug with a wrench.

Be careful not to overtighten the plug, as this can damage the threads.

5. Allow the oil to drain into the oil pan.

This may take several minutes.

6. Replace the oil drain plug.

Tighten the plug securely, but do not overtighten.

7. Remove the old oil filter.

Use a wrench to loosen the filter. Be careful not to spill any oil.

8. Apply a thin layer of new oil to the gasket of the new oil filter.

9. Screw on the new oil filter.

Tighten the filter by hand until it is snug. Do not overtighten the filter, as this can damage the threads.

10. Add new oil to the engine.

Use a funnel to pour the new oil into the engine. Add the amount of oil specified in your owner’s manual.

11. Check the oil level.

Use the dipstick to check the oil level. The oil level should be between the “full” and “add” marks on the dipstick.

12. Start the engine and let it run for a few minutes.

This will circulate the new oil throughout the engine.

13. Check for leaks.

Look under the engine for any leaks. If you see any leaks, tighten the oil drain plug or oil filter until the leak stops.

Congratulations! You have now successfully changed the oil in your Club Car Subaru engine.