How to Change Engine Oil in Alto Car

Materials Needed

• New engine oil (refer to your car’s owner’s manual for the recommended type and amount)
• New oil filter
• Oil filter wrench
• 17mm socket wrench
• Funnel
• Oil drain pan
• Gloves
• Safety glasses

Safety Precautions

• Park your car on a level surface and engage the parking brake.
• Allow the engine to cool for at least 30 minutes before starting any work.
• Wear gloves and safety glasses to protect yourself from hot oil and debris.

Step-by-Step Instructions

1. Locate the Oil Drain Plug

Crawl under the car and locate the oil drain plug. It is usually a 17mm bolt located on the bottom of the oil pan.

2. Place the Oil Drain Pan

Position the oil drain pan directly under the oil drain plug.

3. Remove the Oil Drain Plug

Using the 17mm socket wrench, carefully loosen and remove the oil drain plug. Be prepared for the oil to start draining out immediately.

4. Allow the Oil to Drain

Let the oil drain completely into the pan. This may take several minutes.

5. Replace the Oil Drain Plug

Once the oil has stopped draining, clean the drain plug and apply a new washer if necessary. Tighten the drain plug using the 17mm socket wrench.

6. Locate the Oil Filter

The oil filter is usually located near the top of the engine. It is a cylindrical-shaped part with a black cap.

7. Remove the Oil Filter

Using the oil filter wrench, carefully loosen and remove the oil filter. Be careful not to spill any oil.

8. Apply Oil to the New Filter

Before installing the new oil filter, apply a thin layer of clean oil to the rubber gasket on the filter.

9. Install the New Oil Filter

Screw on the new oil filter by hand until it is snug. Then, use the oil filter wrench to tighten it further, about 3/4 of a turn.

10. Fill the Engine with New Oil

Using a funnel, carefully pour the new oil into the engine. Refer to your car’s owner’s manual for the recommended amount.

11. Check the Oil Level

Once the oil has been added, use the dipstick to check the oil level. The oil level should be between the “min” and “max” marks on the dipstick.

12. Start the Engine and Check for Leaks

Start the engine and let it run for a few minutes. Check for any oil leaks around the drain plug and oil filter.

13. Dispose of the Used Oil and Filter Properly

Dispose of the used oil and oil filter according to your local regulations. Never pour used oil down the drain or into the ground.

Additional Tips

• Change your engine oil and oil filter regularly according to the recommended maintenance schedule in your car’s owner’s manual.
• Use high-quality engine oil and oil filters to protect your engine.
• If you are not comfortable changing your engine oil yourself, have it done by a qualified mechanic.

Conclusion

Changing the engine oil in your Alto car is a simple and straightforward task that you can do yourself with the right tools and materials. By following these step-by-step instructions, you can save money and keep your car running smoothly.