Car Mechanic Simulator 2018 Engine Swap Guide
Introduction
In Car Mechanic Simulator 2018, you can swap engines between cars. This can be a complex process, but it can also be very rewarding. If you’re looking to improve the performance of your car, or if you just want to try something new, then this guide is for you.
Before You Start
Before you start, there are a few things you need to do.
- Make sure you have the right tools. You’ll need a socket set, a wrench, and a torque wrench. You may also need some other tools, depending on the engine you’re swapping.
- Find a good place to work. You’ll need a lot of space to work, so make sure you have a garage or a driveway where you can spread out.
- Gather your parts. You’ll need the new engine, the gaskets, and the bolts. You may also need some other parts, depending on the engine you’re swapping.
Step-by-Step Guide
Now that you’re prepared, let’s get started on the engine swap.
1. Remove the old engine
The first step is to remove the old engine. To do this, you’ll need to:
- Disconnect the battery.
- Remove the air intake system.
- Remove the exhaust system.
- Remove the transmission.
- Unbolt the engine from the mounts.
- Lift the engine out of the car.
2. Prepare the new engine
Once you’ve removed the old engine, you need to prepare the new engine for installation.
- Clean the engine block and the cylinder heads.
- Install the new gaskets.
- Install the new bolts.
3. Install the new engine
Now you’re ready to install the new engine.
- Lower the engine into the car.
- Bolt the engine to the mounts.
- Connect the transmission.
- Connect the exhaust system.
- Connect the air intake system.
- Connect the battery.
4. Start the car
Once you’ve installed the new engine, you can start the car.
- Check for leaks.
- Run the engine for a few minutes.
- Check the oil level.
- Check the coolant level.
Conclusion
That’s it! You’ve now successfully swapped the engine in your car. If you have any questions or need any help, please leave a comment below.
