How to Remove Engine in My Summer Car

Materials You’ll Need

1. 10mm socket wrench
2. 13mm socket wrench
3. 15mm socket wrench
4. 17mm socket wrench
5. 19mm socket wrench
6. 21mm socket wrench
7. 22mm socket wrench
8. 24mm socket wrench
9. Engine hoist
10. Chain or strap
11. Floor jack
12. Jack stands

Safety Precautions

Before you begin, be sure to take the following safety precautions:

1. Park your car on a level surface and engage the parking brake.
2. Disconnect the negative terminal of the battery.
3. Allow the engine to cool down completely.
4. Wear safety glasses and gloves.

Step-by-Step Instructions

1. Remove the Hood

1. Locate the two bolts that secure the hood to the hinges.
2. Use a 13mm socket wrench to remove the bolts.
3. Lift the hood off the hinges and set it aside.

2. Drain the Coolant

1. Locate the coolant drain plug on the bottom of the radiator.
2. Place a drain pan under the drain plug.
3. Use a 17mm socket wrench to loosen the drain plug.
4. Allow the coolant to drain completely.

3. Remove the Air Intake

1. Locate the air intake hose that connects the air filter to the carburetor.
2. Use a 10mm socket wrench to loosen the hose clamp.
3. Remove the air intake hose.
4. Locate the air filter housing.
5. Use a 10mm socket wrench to loosen the bolts that secure the air filter housing.
6. Remove the air filter housing and set it aside.

4. Remove the Exhaust Manifold

1. Locate the exhaust manifold that connects the engine to the exhaust pipe.
2. Use a 15mm socket wrench to loosen the nuts that secure the exhaust manifold.
3. Remove the exhaust manifold and set it aside.

5. Remove the Carburetor

1. Locate the carburetor that is mounted on the intake manifold.
2. Use a 13mm socket wrench to loosen the nuts that secure the carburetor.
3. Remove the carburetor and set it aside.

6. Disconnect the Electrical Connections

1. Locate the electrical connections that are attached to the engine.
2. Use a screwdriver or a pair of pliers to disconnect the electrical connections.

7. Remove the Engine Mounts

1. Locate the engine mounts that are located on each side of the engine.
2. Use a 19mm socket wrench to loosen the nuts that secure the engine mounts.
3. Remove the engine mounts.

8. Install the Engine Hoist

1. Position the engine hoist over the engine.
2. Attach the chain or strap to the engine hoist.
3. Hook the chain or strap to the lifting points on the engine.

9. Lift the Engine

1. Slowly lift the engine using the engine hoist.
2. Be careful not to damage any of the components.
3. Once the engine is clear of the transmission, lift it up and out of the car.

Tips

• If you have a helper, it will make the job easier.
• Be sure to torque the bolts to the correct specifications when reassembling the engine.
• If you are having trouble removing the engine, you may need to use a pry bar or a hammer.

Troubleshooting

• If you are unable to remove the engine, check to make sure that all of the bolts have been removed.
• If the engine is stuck, you may need to use a pry bar or a hammer to loosen it.
• If you have any other problems, consult a mechanic.

Conclusion

Removing the engine in your Summer Car can be a challenging task, but it is possible to do it yourself with the right tools and materials. By following the steps in this guide, you can safely remove the engine from your car and perform any necessary repairs or modifications.