How to remove plastic mounting car engine




How to Remove Plastic Engine Mounts

How to Remove Plastic Mounting Car Engine

Safety First

Before you start working on your car, it’s important to take some safety precautions. Park your car on a level surface and engage the parking brake. Allow the engine to cool down completely before you start working. Disconnect the negative terminal of the battery to prevent any electrical accidents.

Locate the Engine Mounts

The location of the engine mounts will vary depending on the make and model of your car. However, they are typically located on the sides or bottom of the engine. Once you have located the engine mounts, you can begin the removal process.

Remove the Nuts and Bolts

The engine mounts are typically held in place by nuts and bolts. Using a wrench or socket, remove the nuts and bolts that are holding the engine mounts in place. Be careful not to drop any of the nuts or bolts into the engine compartment.

Lift the Engine

Once the nuts and bolts have been removed, you can carefully lift the engine up off of the engine mounts. Be sure to use a jack or engine hoist to support the weight of the engine. Do not attempt to lift the engine by hand, as this could cause serious injury.

Remove the Engine Mounts

Once the engine has been lifted, you can remove the engine mounts. The engine mounts may be held in place by additional bolts or screws. Remove these fasteners and then carefully remove the engine mounts from the engine.

Inspect the Engine Mounts

Once the engine mounts have been removed, you should inspect them for damage. If the engine mounts are cracked or damaged, they will need to be replaced. New engine mounts can be purchased from your local auto parts store.

Install the New Engine Mounts

To install the new engine mounts, simply reverse the removal process. Place the new engine mounts in position and then tighten the bolts or screws that hold them in place. Be sure to torque the bolts to the manufacturer’s specifications.

Lower the Engine

Once the new engine mounts have been installed, you can carefully lower the engine back down onto them. Be sure to use a jack or engine hoist to support the weight of the engine. Do not attempt to lower the engine by hand, as this could cause serious injury.

Tighten the Nuts and Bolts

Once the engine has been lowered, you can tighten the nuts and bolts that hold the engine mounts in place. Be sure to torque the nuts and bolts to the manufacturer’s specifications.

Reconnect the Battery

Once the engine mounts have been tightened, you can reconnect the negative terminal of the battery.

Start the Engine

Start the engine and check for any leaks or unusual noises. If everything is working properly, you have successfully removed and replaced the plastic engine mounts.

Like this post? Please share to your friends:
Leave a Reply