- How to Remove Engine Oil from a Car
- Materials You Will Need
- Safety Precautions
- Step-by-Step Instructions
- 1. Gather Your Materials
- 2. Locate the Oil Drain Plug
- 3. Place the Oil Drain Pan
- 4. Remove the Oil Drain Plug
- 5. Allow the Oil to Drain
- 6. Replace the Oil Drain Plug
- 7. Locate the Oil Filter
- 8. Remove the Oil Filter
- 9. Apply a Thin Coat of Oil to the New Oil Filter Gasket
- 10. Install the New Oil Filter
- 11. Add New Engine Oil
- 12. Check the Oil Level
- 13. Start the Engine
- 14. Check for Leaks
- Tips
- Conclusion
How to Remove Engine Oil from a Car
Materials You Will Need
- Oil drain pan
- Funnel
- New engine oil
- New oil filter
- Wrench
- Gloves
Safety Precautions
Before you begin, it is important to take the following safety precautions:
- Park the car on a level surface and engage the parking brake.
- Allow the engine to cool down completely.
- Wear gloves to protect your hands from hot oil.
Step-by-Step Instructions
1. Gather Your Materials
Gather all of the materials you will need, as listed above.
2. Locate the Oil Drain Plug
The oil drain plug is typically located on the bottom of the oil pan. It is usually a 17mm or 19mm bolt.
3. Place the Oil Drain Pan
Place the oil drain pan under the oil drain plug. Make sure that the pan is large enough to catch all of the oil that will drain out.
4. Remove the Oil Drain Plug
Using the wrench, carefully remove the oil drain plug. Be careful not to drop the bolt into the oil pan.
5. Allow the Oil to Drain
Allow all of the oil to drain out of the oil pan. This may take several minutes.
6. Replace the Oil Drain Plug
Once all of the oil has drained out, replace the oil drain plug. Tighten the bolt until it is snug.
7. Locate the Oil Filter
The oil filter is typically located near the top of the engine. It is usually a cylindrical-shaped canister with a black cap.
8. Remove the Oil Filter
Using the wrench, carefully remove the oil filter. Be careful not to spill any oil.
9. Apply a Thin Coat of Oil to the New Oil Filter Gasket
Apply a thin coat of oil to the gasket of the new oil filter. This will help to create a seal and prevent leaks.
10. Install the New Oil Filter
Screw the new oil filter onto the engine by hand. Tighten the filter until it is snug.
11. Add New Engine Oil
Using the funnel, add new engine oil to the engine. Refer to your car’s owner’s manual for the correct amount of oil to add.
12. Check the Oil Level
Once you have added the new engine oil, check the oil level using the dipstick. The oil level should be between the “full” and “add” marks on the dipstick.
13. Start the Engine
Start the engine and let it run for a few minutes. This will help to circulate the new oil throughout the engine.
14. Check for Leaks
Once the engine has been running for a few minutes, check for any leaks around the oil drain plug or oil filter. If you see any leaks, tighten the bolts or replace the gaskets as necessary.
Tips
- If you are not comfortable changing the oil yourself, you can take your car to a mechanic.
- It is important to change your engine oil regularly to keep your car running smoothly.
- Dispose of the used oil properly at a recycling center.
Conclusion
Changing your engine oil is a relatively simple task that you can do yourself. By following these steps, you can safely and effectively remove the old engine oil from your car.
