How to Put Oil in Engine Car Mechanic Simulator 2018

Step 1: Gather your materials.

You will need the following materials to put oil in your engine:

* A funnel
* A new oil filter
* New oil
* A wrench
* A rag

Step 2: Locate the oil drain plug.

The oil drain plug is typically located on the bottom of the oil pan. It is usually a 17mm bolt.

Step 3: Place the drain pan under the oil drain plug.

The drain pan is used to catch the old oil that will drain out of the engine. Make sure the pan is large enough to catch all of the oil.

Step 4: Loosen the oil drain plug.

Use the wrench to loosen the oil drain plug. Be careful not to drop the bolt into the drain pan.

Step 5: Allow the oil to drain.

Allow the oil to drain completely into the drain pan. This may take a few minutes.

Step 6: Replace the oil drain plug.

Once the oil has drained, replace the oil drain plug. Tighten the plug until it is snug.

Step 7: Locate the oil filter.

The oil filter is typically located near the top of the engine. It is a cylindrical-shaped object with a black cap.

Step 8: Remove the oil filter.

Use the wrench to loosen the oil filter. Be careful not to spill any oil.

Step 9: Apply a thin layer of new oil to the gasket of the new oil filter.

This will help to create a seal and prevent leaks.

Step 10: Screw on the new oil filter.

Hand-tighten the oil filter until it is snug. Do not overtighten the filter.

Step 11: Add new oil to the engine.

Use the funnel to add new oil to the engine. Add oil until the dipstick reads full.

Step 12: Check for leaks.

Start the engine and let it run for a few minutes. Check for any leaks around the oil drain plug and oil filter.

Step 13: Dispose of the old oil and filter.

Dispose of the old oil and filter according to your local regulations.

Congratulations! You have now successfully put oil in your engine.