How to Put Oil in Engine | Car Mechanic Simulator

Step 1: Gather Your Materials

You will need the following materials to put oil in your engine:

1. New oil (check your car’s manual for the recommended type and amount)
2. Oil filter
3. Oil filter wrench
4. Funnel
5. Rags

Step 2: Locate the Oil Pan

The oil pan is located at the bottom of the engine. It is a large, metal pan that holds the oil.

Step 3: Drain the Old Oil

To drain the old oil, place the oil pan under the engine and loosen the oil drain plug. Be careful, the oil may be hot.

Step 4: Replace the Oil Filter

Once the old oil has drained, replace the oil filter. To do this, use the oil filter wrench to loosen the old filter and then screw on the new filter.

Step 5: Add the New Oil

Use the funnel to add the new oil to the engine. Add the amount of oil recommended in your car’s manual.

Step 6: Check the Oil Level

Once you have added the new oil, check the oil level to make sure it is at the correct level. To do this, pull out the oil dipstick and wipe it off. Then, reinsert the dipstick and pull it out again. The oil level should be between the two marks on the dipstick.

Step 7: Dispose of the Old Oil and Filter

Once you have changed the oil, dispose of the old oil and filter properly. You can take them to your local auto parts store or recycling center.

Troubleshooting

If you have any problems changing the oil in your engine, here are some troubleshooting tips:

1. If you cannot loosen the oil drain plug, you may need to use a penetrating oil.
2. If you cannot remove the old oil filter, you may need to use an oil filter wrench.
3. If you add too much oil to the engine, you may need to drain some out.
4. If you do not add enough oil to the engine, you may damage the engine.

Conclusion

Changing the oil in your engine is a relatively simple task that you can do yourself. By following these steps, you can save money and keep your car running smoothly.