How to Put Engine in Car in CMS18

Step 1: Remove the Old Engine

The first step is to remove the old engine. To do this, you will need to:

1. Disconnect the battery.
2. Remove the air filter.
3. Remove the radiator hoses.
4. Remove the spark plugs.
5. Remove the exhaust manifolds.
6. Remove the transmission bolts.
7. Lift the engine out of the car.

Step 2: Prepare the New Engine

Once the old engine is removed, you need to prepare the new engine for installation. To do this, you will need to:

1. Install the new spark plugs.
2. Install the new exhaust manifolds.
3. Install the new transmission bolts.
4. Install the new radiator hoses.
5. Install the new air filter.
6. Connect the battery.

Step 3: Install the New Engine

Now that the new engine is prepared, you can install it in the car. To do this, you will need to:

1. Lower the engine into the car.
2. Bolt the engine to the transmission.
3. Connect the radiator hoses.
4. Connect the exhaust manifolds.
5. Connect the spark plugs.
6. Connect the air filter.
7. Connect the battery.

Step 4: Start the Engine

Once the engine is installed, you can start it. To do this, turn the key to the “on” position and wait for the fuel pump to prime. Then, turn the key to the “start” position and the engine should start.

Troubleshooting

If you have any problems starting the engine, there are a few things you can check:

* Make sure that all of the connections are tight.
* Make sure that the spark plugs are properly gapped.
* Make sure that the fuel filter is not clogged.
* Make sure that the battery is fully charged.

If you have checked all of these things and the engine still will not start, you may need to take it to a mechanic for further diagnosis.

Conclusion

Installing an engine in a car is a complex task, but it is one that can be completed by a skilled mechanic. By following the steps in this guide, you can safely and easily install an engine in your car.