How to Flush a Car Engine Block K-Seal

Introduction

K-Seal is a liquid sealant that can be used to stop leaks in car engine blocks. It is a temporary solution, and it is important to flush the engine block as soon as possible after using K-Seal. Flushing the engine block will remove any remaining K-Seal and help to prevent it from causing problems in the future.

Materials

You will need the following materials to flush a car engine block K-Seal:

* A bucket
* A garden hose
* A funnel
* A new engine oil filter
* New engine oil

Instructions

1. Park the car on a level surface and turn off the engine.
2. Open the hood and locate the engine block.
3. Place the bucket under the engine block.
4. Attach the garden hose to the funnel and insert the funnel into the oil filler hole.
5. Turn on the water and let it run through the engine block for 10-15 minutes.
6. Turn off the water and remove the funnel.
7. Replace the engine oil filter.
8. Add new engine oil to the engine.
9. Start the engine and let it run for a few minutes.
10. Check for leaks.

Tips

* If you do not have a funnel, you can use a piece of cardboard or plastic to create one.
* You can also use a pressure washer to flush the engine block.
* Be sure to wear gloves and eye protection when flushing the engine block.
* If you have any questions, consult a mechanic.

Conclusion

Flushing a car engine block K-Seal is a simple process that can be completed in about 30 minutes. By following the instructions in this article, you can help to prevent problems from occurring in the future.