How to Engine Swap in Car Mechanic Simulator 2021

1. Gather the necessary tools and materials

Before you begin, you will need to gather the following tools and materials:

1. Engine hoist
2. Engine stand
3. Socket wrench set
4. Torque wrench
5. New engine
6. New gaskets
7. New oil filter
8. New coolant

2. Remove the old engine

Once you have the necessary tools and materials, you can begin removing the old engine. To do this, you will need to:

1. Disconnect the battery.
2. Drain the oil and coolant.
3. Remove the air intake system.
4. Remove the exhaust system.
5. Remove the fuel lines.
6. Remove the electrical wiring.
7. Remove the transmission.
8. Attach the engine hoist to the engine.
9. Lift the engine out of the car.

3. Install the new engine

Once the old engine has been removed, you can install the new engine. To do this, you will need to:

1. Place the new engine on the engine stand.
2. Attach the transmission to the engine.
3. Install the new gaskets.
4. Lower the engine into the car.
5. Attach the engine hoist to the engine.
6. Tighten the engine mounts.
7. Connect the electrical wiring.
8. Connect the fuel lines.
9. Connect the exhaust system.
10. Connect the air intake system.
11. Fill the engine with oil and coolant.
12. Connect the battery.

4. Start the engine and check for leaks

Once the new engine has been installed, you can start the engine and check for leaks. To do this, you will need to:

1. Start the engine.
2. Let the engine idle for a few minutes.
3. Check for leaks under the car.
4. If there are any leaks, tighten the appropriate bolts or replace the gaskets.

5. Test drive the car

Once you have checked for leaks, you can test drive the car. To do this, you will need to:

1. Drive the car around the block.
2. Listen for any unusual noises.
3. Check for any leaks.
4. If there are any problems, take the car back to the garage and troubleshoot the issue.

6. Enjoy your new engine!

Once you have test driven the car and are satisfied with its performance, you can enjoy your new engine!