How to Engine Swap Car Mechanic Simulator 2018

Introduction

An engine swap is a complex and time-consuming process, but it can be very rewarding. If you’re thinking about swapping the engine in your Car Mechanic Simulator 2018 vehicle, here’s a step-by-step guide to help you get started.

Step 1: Gather Your Tools and Materials

Before you start, you’ll need to gather all of the necessary tools and materials. This includes:

• An engine hoist
• A set of wrenches
• A set of sockets
• A torque wrench
• A new engine
• A new transmission
• A new driveshaft
• A new exhaust system
• A new cooling system
• A new fuel system
• A new electrical system

Step 2: Remove the Old Engine

Once you have all of your tools and materials, you can begin the process of removing the old engine. To do this, you’ll need to:

1. Disconnect the battery.
2. Drain the coolant.
3. Remove the air intake system.
4. Remove the exhaust system.
5. Disconnect the fuel lines.
6. Disconnect the electrical connectors.
7. Remove the transmission.
8. Remove the driveshaft.
9. Remove the engine mounts.
10. Lift the engine out of the vehicle using the engine hoist.

Step 3: Install the New Engine

Once the old engine is removed, you can install the new engine. To do this, you’ll need to:

1. Lower the new engine into the vehicle using the engine hoist.
2. Install the engine mounts.
3. Connect the driveshaft.
4. Connect the transmission.
5. Connect the electrical connectors.
6. Connect the fuel lines.
7. Install the exhaust system.
8. Install the air intake system.
9. Fill the coolant system.
10. Connect the battery.

Step 4: Start the Engine

Once the new engine is installed, you can start it up. To do this, you’ll need to:

1. Turn the key to the “on” position.
2. Wait for the fuel pump to prime.
3. Turn the key to the “start” position.

Step 5: Test Drive the Vehicle

Once the engine is running, you can test drive the vehicle to make sure that everything is working properly. To do this, you’ll need to:

1. Drive the vehicle around the block.
2. Check for any leaks or unusual noises.
3. Make sure that the engine is running smoothly.

Conclusion

Congratulations! You have now successfully swapped the engine in your Car Mechanic Simulator 2018 vehicle. This is a complex and time-consuming process, but it can be very rewarding. If you follow the steps outlined in this guide, you should be able to complete the swap without any problems.