How to Build an Engine in Car Mechanic Simulator 2021

Step 1: Gather Your Tools and Materials

Before you can start building an engine, you’ll need to gather the following tools and materials:

* **Tools:**
* Socket wrench set
* Torque wrench
* Screwdriver set
* Pliers
* Hammer
* Gasket scraper
* **Materials:**
* Engine block
* Cylinder heads
* Pistons
* Rings
* Bearings
* Gaskets
* Oil
* Antifreeze

Step 2: Disassemble the Old Engine

Once you have your tools and materials, you can begin disassembling the old engine. Start by removing the following components:

* **Intake and exhaust manifolds:** Use a socket wrench to remove the bolts that hold the manifolds in place.
* **Cylinder heads:** Use a socket wrench to remove the bolts that hold the cylinder heads in place.
* **Pistons:** Use a piston ring compressor to remove the piston rings. Then, use a hammer to tap the pistons out of the engine block.
* **Bearings:** Use a screwdriver to remove the bearing caps. Then, use a hammer to tap the bearings out of the engine block.

Step 3: Clean the Engine Block

Once you have disassembled the old engine, it’s important to clean the engine block thoroughly. Use a gasket scraper to remove any old gaskets or sealant. Then, use a degreaser to remove any oil or grease.

Step 4: Assemble the New Engine

Now that you have cleaned the engine block, you can begin assembling the new engine. Start by installing the following components:

* **Bearings:** Install the bearings in the engine block. Make sure that the bearings are properly aligned.
* **Pistons:** Install the pistons in the engine block. Make sure that the pistons are properly aligned with the bearings.
* **Rings:** Install the piston rings on the pistons. Make sure that the rings are properly aligned.
* **Cylinder heads:** Install the cylinder heads on the engine block. Make sure that the cylinder heads are properly aligned.
* **Intake and exhaust manifolds:** Install the intake and exhaust manifolds on the cylinder heads. Make sure that the manifolds are properly aligned.

Step 5: Tighten All of the Bolts

Once you have assembled the new engine, you need to tighten all of the bolts. Use a torque wrench to tighten the bolts to the proper specifications.

Step 6: Add Oil and Antifreeze

Once you have tightened all of the bolts, you need to add oil and antifreeze to the engine. Fill the oil pan with oil and fill the radiator with antifreeze.

Step 7: Start the Engine

Once you have added oil and antifreeze, you can start the engine. Let the engine run for a few minutes to make sure that it is running properly.

Step 8: Test Drive the Car

Once the engine is running properly, you can test drive the car. Take the car for a drive around the block to make sure that everything is working properly.

Conclusion

Building an engine in Car Mechanic Simulator 2021 is a challenging but rewarding task. By following the steps in this guide, you can build an engine that will make your car run like new.