How to Swap Engines in Car Mechanic Simulator 2021
Swapping engines in Car Mechanic Simulator 2021 is a complex process, but it can be very rewarding. By following these steps, you can successfully swap an engine and get your car back on the road.
Step 1: Gather Your Tools and Materials
Before you start, you will need to gather the following tools and materials:
* A new engine
* An engine hoist
* A set of wrenches
* A set of sockets
* A torque wrench
* A fluid drain pan
* New engine oil and filter
* New coolant
Step 2: Prepare the Car
Once you have your tools and materials gathered, you need to prepare the car for the engine swap. This involves disconnecting the battery, draining the fluids, and removing the old engine.
To disconnect the battery, simply loosen the negative terminal bolt and remove the cable. Be careful not to touch the positive terminal, as this can cause a spark.
To drain the fluids, you will need to locate the drain plugs for the oil, coolant, and transmission fluid. Once you have found the drain plugs, place the fluid drain pan under the car and loosen the plugs. Allow the fluids to drain completely.
To remove the old engine, you will need to use the engine hoist. First, attach the engine hoist to the engine. Then, use the hoist to lift the engine out of the car. Be careful not to damage the car or the engine during this process.
Step 3: Install the New Engine
Once you have removed the old engine, you can install the new engine. To do this, simply reverse the steps that you took to remove the old engine. First, use the engine hoist to lift the new engine into the car. Then, bolt the engine into place.
Once the engine is bolted into place, you can reconnect the fluids. To do this, simply locate the fill plugs for the oil, coolant, and transmission fluid. Then, fill the fluids to the appropriate levels.
Finally, reconnect the battery. To do this, simply tighten the negative terminal bolt.
Step 4: Start the Car
Once you have reconnected the battery, you can start the car. If the car starts, then you have successfully swapped the engine. However, if the car does not start, then you will need to troubleshoot the problem.
Troubleshooting
If the car does not start, there are a few things that you can check. First, make sure that all of the fluids are filled to the appropriate levels. Then, check the spark plugs and wires to make sure that they are in good condition. Finally, check the fuel system to make sure that it is working properly.
If you are still having trouble getting the car to start, then you may need to take it to a mechanic.
Conclusion
Swapping engines in Car Mechanic Simulator 2021 can be a complex process, but it is also very rewarding. By following these steps, you can successfully swap an engine and get your car back on the road.
