How to Create an Engine in Car Mechanic Simulator 2018

Introduction

Creating an engine in Car Mechanic Simulator 2018 can be a rewarding and challenging experience. By following these steps, you can create a custom engine that will give your car the performance you desire.

Step 1: Gather the necessary materials

Before you can start creating your engine, you will need to gather the following materials:

• A set of engine components (pistons, crankshaft, camshaft, etc.)
• A set of tools (wrenches, screwdrivers, etc.)
• A workbench

Step 2: Assemble the engine block

The first step in creating an engine is to assemble the engine block. This is the main part of the engine that houses the pistons, crankshaft, and camshaft.

1. Place the engine block on the workbench.
2. Install the pistons into the engine block.
3. Install the crankshaft into the engine block.
4. Install the camshaft into the engine block.

Step 3: Install the cylinder heads

The next step is to install the cylinder heads. These are the parts of the engine that seal the combustion chambers and allow the valves to open and close.

1. Place the cylinder heads on the engine block.
2. Install the head bolts.
3. Torque the head bolts to the specified torque.

Step 4: Install the intake and exhaust manifolds

The intake and exhaust manifolds are the parts of the engine that allow air and fuel to enter the engine and exhaust gases to exit the engine.

1. Place the intake manifold on the engine.
2. Install the intake manifold bolts.
3. Torque the intake manifold bolts to the specified torque.
4. Place the exhaust manifold on the engine.
5. Install the exhaust manifold bolts.
6. Torque the exhaust manifold bolts to the specified torque.

Step 5: Install the timing belt

The timing belt is the part of the engine that synchronizes the movement of the crankshaft and the camshaft.

1. Place the timing belt on the crankshaft.
2. Install the timing belt on the camshaft.
3. Adjust the timing belt tension.

Step 6: Install the oil pan

The oil pan is the part of the engine that holds the oil that lubricates the engine.

1. Place the oil pan on the engine.
2. Install the oil pan bolts.
3. Torque the oil pan bolts to the specified torque.

Step 7: Install the engine in the car

Once the engine is assembled, you can install it in the car.

1. Place the engine in the engine bay.
2. Connect the engine to the transmission.
3. Connect the engine to the exhaust system.
4. Connect the engine to the electrical system.

Conclusion

Creating an engine in Car Mechanic Simulator 2018 can be a rewarding experience. By following these steps, you can create a custom engine that will give your car the performance you desire.