Car Mechanic Simulator Engine Build

Introduction

In Car Mechanic Simulator, you can build your own custom engine from scratch. This is a complex and time-consuming process, but it can be very rewarding. In this guide, we will walk you through the steps on how to build an engine in Car Mechanic Simulator.

Step 1: Gather the necessary parts

The first step is to gather all of the necessary parts to build an engine. These parts include:

• Engine block
• Crankshaft
• Pistons
• Connecting rods
• Camshaft
• Valves
• Valve springs
• Oil pump
• Water pump
• Timing belt or chain
• Intake manifold
• Exhaust manifold
• Turbocharger (optional)
• Supercharger (optional)

Step 2: Assemble the engine block

Once you have all of the necessary parts, you can begin assembling the engine block. The engine block is the foundation of the engine, and it houses the crankshaft, pistons, and connecting rods.

To assemble the engine block, first place the crankshaft in the block. Then, install the pistons onto the crankshaft. Finally, install the connecting rods onto the pistons.

Step 3: Install the camshaft

The camshaft is responsible for opening and closing the valves. To install the camshaft, first place it in the cylinder head. Then, install the valve springs and valves.

Step 4: Install the intake and exhaust manifolds

The intake and exhaust manifolds are responsible for directing air and fuel into the engine, and for directing exhaust gases out of the engine.

To install the intake and exhaust manifolds, first place them on the cylinder head. Then, tighten the bolts that hold them in place.

Step 5: Install the oil pump and water pump

The oil pump is responsible for circulating oil throughout the engine. The water pump is responsible for circulating water through the engine to keep it cool.

To install the oil pump and water pump, first place them on the engine block. Then, tighten the bolts that hold them in place.

Step 6: Install the timing belt or chain

The timing belt or chain is responsible for synchronizing the movement of the camshaft and crankshaft.

To install the timing belt or chain, first place it on the camshaft and crankshaft. Then, tension the belt or chain.

Step 7: Install the turbocharger or supercharger (optional)

A turbocharger or supercharger can be installed to increase the power output of the engine.

To install a turbocharger or supercharger, first place it on the exhaust manifold. Then, connect the turbocharger or supercharger to the intake manifold.

Step 8: Test the engine

Once you have assembled the engine, you need to test it to make sure that it works properly.

To test the engine, first connect it to a battery. Then, start the engine and let it idle for a few minutes.

Conclusion

Building an engine in Car Mechanic Simulator is a complex and time-consuming process, but it can be very rewarding. By following the steps outlined in this guide, you can build a custom engine that will make your car perform at its best.