Car Mechanic Simulator 2021: How to Put Oil in Engine

Step 1: Gather your materials

You will need the following materials to put oil in your engine:

* New oil filter
* New oil
* Funnel
* Rags
* Wrench

Step 2: Locate the oil drain plug

The oil drain plug is usually located on the bottom of the oil pan. It is a bolt that has a washer on it.

Step 3: Place the oil pan under the drain plug

Place the oil pan under the drain plug so that it will catch the old oil when it drains out.

Step 4: Remove the drain plug

Use the wrench to loosen the drain plug. Be careful not to drop the bolt into the oil pan.

Step 5: Drain the old oil

Allow the old oil to drain out of the oil pan. This may take a few minutes.

Step 6: Replace the drain plug

Once the old oil has drained out, replace the drain plug. Tighten the bolt until it is snug.

Step 7: Locate the oil filter

The oil filter is usually located near the top of the engine. It is a cylindrical-shaped object with a black cap.

Step 8: Remove the oil filter

Use the wrench to loosen the oil filter. Be careful not to spill any oil.

Step 9: Apply oil to the gasket of the new oil filter

Apply a thin layer of oil to the gasket of the new oil filter. This will help to create a seal between the filter and the engine.

Step 10: Install the new oil filter

Screw the new oil filter onto the engine. Tighten the filter until it is snug.

Step 11: Add new oil to the engine

Use the funnel to add new oil to the engine. Add oil until the dipstick reads full.

Step 12: Check for leaks

Start the engine and let it run for a few minutes. Check for any leaks around the oil drain plug and the oil filter.

Step 13: Dispose of the old oil and filter

Dispose of the old oil and filter according to your local regulations.

Congratulations! You have now successfully changed the oil in your engine.